[Top] [All Lists]

Re: [TowerTalk] Rohn 45 questions

To: "Gregg Seidl" <>, <>
Subject: Re: [TowerTalk] Rohn 45 questions
From: "Mark Robinson" <>
Date: Thu, 6 Oct 2011 06:18:57 -0400
List-post: <">>
There is this..not cheap but it does the job. It fits inside the legs of a 
standard section.

Mark N1UK

----- Original Message ----- 
From: "Gregg Seidl" <>
To: <>
Sent: Wednesday, 05 October, 2011 8:24 PM
Subject: [TowerTalk] Rohn 45 questions

>I have a small dilmenia that I hope I can get a few answers.
> In my younger days I would get "pointy top" Rohn sections and cut the top 
> off and then put a rotor plate at the top and put the thrust bearing there 
> with the rotor plate at the bottom of the top section. This worked good 
> for years. I now get the flat plate top section but have one cut off 
> pointy top tower left and want to convert it to a flat plate without 
> getting an expensive Rohn 45 flat plate section plus shipping etc.
> I see that Rohn 45 rotor plates fit anywhere along the tower section so I 
> can mount it about 4 feet from the top. My question is this:does someone 
> make a flat plate that fits OVER the legs. I can easily make the legs the 
> same length and drill holes to secure the flat plate to the legs. Of 
> course I'd paint it with cold spray galvanizing.
> I see Norms Fab makes a plate that fits into the legs but that would be a 
> little more diffucult for me to drill or at least I think it fits into the 
> legs.
> Looking for any ideas other then take the top section off and install a 
> flat plate section. Thats the obvious.
> Gregg  K9KL
> _______________________________________________
> _______________________________________________
> TowerTalk mailing list


TowerTalk mailing list

<Prev in Thread] Current Thread [Next in Thread>