The hole was cut for a 2" mast but Rohn also sold a cast
metal bushing to stick in that hole, one for 1 1/2" masts
and one for 1 1/4" mast. Not too fancy.
Jim - K5LAD
On 10 Oct 2011 at 9:23, jcjacobsen@q.com wrote:
> I seem to remember that someone (Rohn?) used to market an "Amateur
> Bearing" that was nothing more than a good sized chunk of Oak with a
> hole drilled in it. Just bolt it to the top plate and go for it.
>
> K9WN Jake
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
===========================================
=====
Growing old is like being increasingly penalized
for a crime you haven't committed.
-- Anthony Powell
-----------------
Visit my webpages at:
http://www.hayseed.net/~jpk5lad/
===========================================
=====
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|