The Tri-EX mast sleeve is designed for 2" tubing (OD= 2.0", don't confuse
pipe sizes which generally describe the ID of the pipe. 1-1/2" Pipe OD
measures slightly under 2" dia. and a little sloppy in the Tri-Ex sleeve. I
have made stainless steel shims to fill the gap. (roll flat stock into a
circle). With lubrication the sleeve will act as a bearing, but it can easily
bind depending on mast length, centering and wind speed. Replace the
locking bolt on the sleeve with a Zerx fitting to simplify lubrication. It is
also a good idea to make a grease seal at the bottom of the sleeve - a
piece of leather belting and a hose clamp is a simple method.
Just remember plumbing pipe does not have the strength of quality 2" mast
In a message dated 10/11/2011 11:03:51 P.M. Eastern Daylight Time,
Date: Tue, 11 Oct 2011 16:49:02 -0700 (PDT)
From: Chris Merchant KA1LMR <email@example.com>
Subject: [TowerTalk] Tri-EX Tashjain Towers fit 2" mast ?
Content-Type: text/plain; charset=iso-8859-1
I notice the 4" sleeve below the thrust bearing of a WT-51 tower is just a
hair over 2"? ID. I am wondering if an actual 2" steel 1026 Steel pipe
will comfortably fit inside and turn? without a problem when greased?? I
tested a 1 7/8 pipe? there didnt seem to be much play in the sleave but was a
little sloppy fit? in the upper? thrust bearing lip. just dont want to spend
$300 or so on a actual 2" mast if its not going to fit.
TowerTalk mailing list