It should be fairly trivial to make or modify a wall mount to
accommodate a rotated tower. I don't like to see guys pulling in the
wrong direction, though on a lightly loaded short tower you could get
away with it.
On 10/23/2011 8:15 PM, R. Michael Barts wrote:
> The normal do-what-the-manufacturer-says installation pictures always seem
> to assume that the direction of the guys are perpendicular to the tower face
> opposite leg to which the guy is attached. I am looking at an installation
> with wall mount+ guys. But if I install guys in the conventional way, I face
> the possibility that one of the guys will interfere with a corner of the
> house. Would it be possible (safe?) if the guy anchor points were rotated 15
> deg from the 'normal'. All three guy points would be rotated, so 120 deg
> separation would be maintained, but would the rotated guy directions place
> any additional torque on the tower?
> 73, Mike N4GU
TowerTalk mailing list