[Top] [All Lists]

Re: [TowerTalk] Tower Base Round or Square?

To: "TowerTalk" <>
Subject: Re: [TowerTalk] Tower Base Round or Square?
From: "Larry" <>
Reply-to: Larry <>
Date: Wed, 26 Oct 2011 18:27:56 -0400
List-post: <">>
The current Rohn 25G/45G brochures actually show round bases but the
notes allow for a square base. The GSR (solid rod rails) brochure shows
a square base with a tower piece embedded in the concrete base. The older
25G/45G data had square base recommendations. I suspect it does not make
much difference. The square hole will take more concrete and would be easier
to dig with a backhoe. If you had access to big posthole digger then the 
hole is probably easier a bit less concrete.

73, Larry  W6NWS
----- Original Message ----- 
From: "Richard Thorne" <>
To: "Towertalk" <>
Sent: Wednesday, October 26, 2011 1:28 PM
Subject: [TowerTalk] Tower Base Round or Square?

> I'm finally getting some dirt work done in the next day or two at my new
> place which will include holes/concrete for my 45g tower.
> I plan on using a pier pin install, so does it matter if the base is
> square or round?  The rohn book calls for a 2' 6" square hole 4' deep
> (I'm designing the tower based on 90mhp winds with a height of 120').
> It would be easier to use a 36" auger to dig the hole.  Since I'm going
> with a pier pin I don't see that there would be any twisting moments on
> the concrete base, it would only be there to hold the tower up.  But I'm
> not an engineer, hence the question.
> Thanks
> Rich - N5ZC
> _______________________________________________
> _______________________________________________
> TowerTalk mailing list


TowerTalk mailing list

<Prev in Thread] Current Thread [Next in Thread>