On 12/18/2011 1:55 PM, firstname.lastname@example.org wrote:
> They are pretty easy to make out of aluminum angle stock. You can buy the
> material already cut to length and you just need to drill four holes for the
Just be sure to use material that will provide at least twice the
strength needed. This is not a place where "just sufficient" inspires
My preference would be steel channel with a brace. I'd also add a piece
on the end sticking up to prevent slipping off.
Yes, it's more elaborate than absolutely needed, but if you were selling
them it would be required.
They are easy to make and there'd probably be a good market, but I sure
wouldn't want the liability.
> W9IIX no longer makes mast steps. I used to have a listing of someone who
> makes aluminum mast steps, but I can't find it. I need about 4 steps for a
> mast. Does not have to be aluminum. Any ideas of where I can get them?
> Chuck W5PR
TowerTalk mailing list