I just bought one of those motor covers for my HDX-555, knowing that,
because the motor is mounted *underneath* the gearbox, I would have to
remove the motor and drill holes in the top of the cover and then
reassemble everything. I did not, however, reckon with the amount that
the electrical box sticks out from the motor casing: one side of the
motor cover will have to splay outward somewhat to clear the electrical box.
Where do pool motors typically have their electrical connections? This
cover is supposed to be OK even for 2hp motors, and I don't think mine
is that big.
On 12/12/11 08:23 pm, Julio Peralta wrote:
> This should take care of the problem.
> Julio, W4HY
> -----Original Message-----
> From: email@example.com
> [mailto:firstname.lastname@example.org] On Behalf Of Fred Hurd
> Sent: Monday, December 12, 2011 7:12 PM
> To: email@example.com
> Subject: [TowerTalk] Rain Water Getting Into TX-472 Motors
> The motor unit installed on my TX-472 US Tower has been soaked internally by
> rain water leaking into the motor housing resulting in motor rusting and
> corrosion internally. Now the motor is drawing too much current to start up
> and blowing the electrical source fuse. Contact with the motor manufacturer
> reveals that these motors were not designed to be exposed constantly to
> weather but used primarily with generators within weather protected housing.
> I am curious if other TX Tower owners have experienced similar problems with
> the motors being damaged by rain water. Has anyone found a replacement motor
> that can survive heavy rain? Or is the only solution using a cover over the
TowerTalk mailing list