[Top] [All Lists]

Re: [TowerTalk] Yaesu Rotor Pinning Alternative

To: <>, <>
Subject: Re: [TowerTalk] Yaesu Rotor Pinning Alternative
From: "Dick Green WC1M" <>
Date: Sun, 8 Apr 2012 00:35:18 -0400
List-post: <">>
It depends on the mast clamp. The M2 Orion is a big rotator, but the mast
clamp design is seriously flawed, guaranteed to slip with a big load.

The G-2800 is pretty good as clamps go, but regular inspection of any
antenna/mast clamp is advisable. A friend of mine installed a G-2800 many
years ago, I think it was 15 or 20 years, and it held 16 sq ft of antennas
stacked on the mast quite nicely -- until it didn't. The mast was pinned,
but over that long period of time the nuts on the u-bolts gradually
loosened, and the mast was able to turn just enough to eventually shear off
the bolt used for pinning. Then the freewheeling began.

I don't think there's any such thing as a maintenance-free tower. It's
amazing how long my friend's rotator held the mast, but regular
inspection/tightening would have been a good idea nonetheless. As far as
rotator and mast clamps go, if you have a good system and the bolts are
torqued properly, an inspection every couple of years will probably be

73, Dick WC1M

> -----Original Message-----
> From: []
> Sent: Saturday, April 07, 2012 10:30 AM
> To:
> Subject: Re: [TowerTalk] Yaesu Rotor Pinning Alternative
> I used two Yaesu G-2800 DXA rotators at P40A to turn 10m though 40m
> monobanders.  The wind almost never stops in Aruba and I never had a
> failure or slippage when installing it according to the manufacture's
> specifications.   Your G-1000 probably failed because it was too small
> for
> your application.  Buy a big enough rotator and you don't have to worry
> about a "slippage fuse" for heavy winds.
> John KK9A
> Subject:[TowerTalk] Yaesu Rotor Pinning Alternative From:Tony
> <> Date:Fri, 06 Apr 2012 23:23:12 -0400
> All,
> I'll be installing a new Yaesu G-2800 rotor next week to replace a
> broken G-1000. The rotor had been making noise before it finally stopped
> turning so it's most likely mechanical failure. The mast pin did not
> shear, but there is heavy wear.
> I was thinking of an alternative to pinning to avoid another expensive
> failure; some sort of rubber material to grip the mast. The problem is
> that you can't apply much torque to the aluminum clamps so I'm not sure
> if it will hold. What's really needed is a steel set of replacement
> clamps.
> So, is anyone using a Yaesu G-2800 without a pin?
> Tony


TowerTalk mailing list

<Prev in Thread] Current Thread [Next in Thread>