On 4/14/2012 4:39 PM, K8RI wrote:
> I finished rebuilding the Ham V/IV some time ago and am ready to put
> the top section on the 50' 25G. What I've discovered is there is no way
> to fit the Ham V into the tower except lowering it down from the top. I
> will not cut a side brace to make room nor bend one very far that can't
> be straightened to look proper. I do not want to weaken the tower
> ...*any where*
> Any socially acceptable suggestions?
Make a bolt-on brace to replace what you cut out - maybe a piece of
angle and a couple of u-bolts?
TowerTalk mailing list