Bob,
This is almost ok, but using 468/f is a typical length for a halfwave
dipole including the shortening due to end effect (5%).
At 7.15 the wavelength is 983.571/7.15 = 137.56 feet. In your coax with
VF=0.6779, this would be 93.25 feet.
So a quarter wavelength line would be 0.25*93.25 = 23.31 feet and
a three quarter wavelength line would be 0.75*92.25 = 69.94 feet.
When I modeled this in EZNEC, with 3/4 wl line between the verticals and
a 3/4 wl line to the Tx from vertical #1, the beam goes to the SW. With
5 ohms of ground loss, the gain is 2.56 dBi and the F/B is 8.8 dB. Feed
Z is 86.2  J 50.02 ohms or a 2.48:1 SWR at 7.15 MHz.
Let me know if you need more info.
73, Terry N6RY
On 20120502 8:44 AM, Bob Ad5vj wrote:
> My first Rodeo on phasing, need confirmation please.
>
> I am working on 2 34' phased verticals spaced 34' for 40 meters pointing in a
> NE/SW line.
>
> SW ant we call #1
> NE ant we call #2
>
> I am wanting ONLY NE direction.
>
> Using my MFJ259B I have determined the length of coax I have (RG11) to
> measure 106.2' to the fault.
>
> Physically measuring the coax it comes to exactly 72'.
>
> Dividing 72/106.2 I get a measured velocity factor of .6779 according to the
> MFJ manual.
>
> (468/7.150)/2 =32.7' per 1/4 wave
> 32.7' X 3 = 98.1818
> for 3/4 wavelength
>
> 98.1818 X .6779 = 66.55'
>
> So this should be the physically measured coax length for the 3/4 wavelength
> going to the #1 vertical.
>
> Then I do the same for a 3/4 coax wavelength from #1 to #2 antenna.
>
>
> Does that sound right?
>
> 73, Bob AD5VJ
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
