On 5/25/2012 9:21 PM, Phil Snyder wrote:
> Does anyone know if this tool, the DXE-UT-8213 designed to prep RG-8
> LMR-400 etc. will work on RG-11? I am thinking not as I thought part of
> the 50/75 ohm characteristic came from the spacing of the shield from
> the center ( I may also be completely wrong on that point). I could be
> all wet on this one as well but figured this might be the place to find
> the right answer, flame or not.
If you go to their page where the prep tool is listed all of the coax
types are listed that the tools were tested on.
and Yes, RG11 is listed for the 8213 tool
TowerTalk mailing list