I just removed a 25G tower and a Ham IV rotator was mounted inside it and no
braces were cut.
Maybe you are working with a T2X rotator?
de Paul, W8AEF
ZF2JI/ZF2TA FO8DX/FO8PLA 8Q7AA XZ0A VU7RG/VU3PYM TX5C A52PP
Sent: Friday, June 01, 2012 6:17 PM
Subject: [TowerTalk] Getting your moneys Worth
A while back I mentioned trying to fit a Han IV into a 25G and not wanting
to cut a brace. As the mast will extend about 12' above the top of the
tower, I did not consider mounting inside the short section with the flat
top plate to be desirable either. Sooo... I finally decided to mount the
rotator externally and run a two section mast down through the
tower. That will leave the rotator 20 feet above ground level and 30
feet below the flat top plate...give or take a tad. I should be able to
stand on the roof and work on it.
TowerTalk mailing list