On 6/1/2012 10:31 PM, Paul Playford wrote:
> I just removed a 25G tower and a Ham IV rotator was mounted inside it and no
> braces were cut.
> Maybe you are working with a T2X rotator?
Actually I'm working with a ham V according to the stamped figures on
the bottom, but the IV and V are identical except for the control head.
A ham down the road was able to put one in his 25G by bending the
braces. These would have to be bent far enough that it'd bend the legs.
I know of others who were able to slide the ham IV in between the braces
at a junction between sections. So there must be substantial variations
> de Paul, W8AEF
> ZF2JI/ZF2TA FO8DX/FO8PLA 8Q7AA XZ0A VU7RG/VU3PYM TX5C A52PP
> -----Original Message-----
> From: K8RI
> Sent: Friday, June 01, 2012 6:17 PM
> To: email@example.com
> Subject: [TowerTalk] Getting your moneys Worth
> A while back I mentioned trying to fit a Han IV into a 25G and not wanting
> to cut a brace. As the mast will extend about 12' above the top of the
> tower, I did not consider mounting inside the short section with the flat
> top plate to be desirable either. Sooo... I finally decided to mount the
> rotator externally and run a two section mast down through the
> tower. That will leave the rotator 20 feet above ground level and 30
> feet below the flat top plate...give or take a tad. I should be able to
> stand on the roof and work on it.
TowerTalk mailing list