I have all of the templates -- but they don't have any dimensions on them!
73 -- Larry -- W1DYJ
----- Original Message -----
From: "Bert Almemo" <email@example.com>
To: "'Larry Banks'" <firstname.lastname@example.org>; "'Tower Talk'"
Sent: Wednesday, August 01, 2012 10:15 PM
Subject: RE: [TowerTalk] Rotator Mounting Dimensions
> Hi Larry,
> I have the manual for TR-44 but there is no drilling template. I found a
> template for the HAM III and I believe it's the same dimensions. I
> the template for you. Good luck!
> 73 Bert, VE3NR
> -----Original Message-----
> From: email@example.com
> [mailto:firstname.lastname@example.org] On Behalf Of Larry Banks
> Sent: Wednesday, August 01, 2012 9:30 PM
> To: Tower Talk
> Subject: [TowerTalk] Rotator Mounting Dimensions
> Hi TT'ers
> I am designing a base plate for mounting an old TR-44 rotator and cannot
> find dimensions anywhere on the Internet. I measure 3" c-to-c from the
> rotator on my workbench. Is this the correct dimension? What size hole?
> Is this the same for modern Hy Gain rotators too?
> (Since I may purchase a new rotator in the future if this one fails, I am
> also going to add holes for Yaesu rotators -- at least I know that the
> correct dimension there is 84mm for all of them.)
> 73 -- Larry -- W1DYJ
> TowerTalk mailing list
TowerTalk mailing list