The fuse is fine. There's a faint "burnt" odor inside the controller.
Transformer secondary voltages look good.
1. Does anyone have a legible copy of the schematic? Yaesu's PDF
version is illegible at the component level.
2. The interconnect diagram clearly shows Q1/D2 connecting to the PSU
PCB via J1007. Can someone please point out where the Q1/D2 circuit
is shown on the schematic diagram?
Thanks & 73,
On Sun, Sep 2, 2012 at 1:18 PM, Barry N1EU <firstname.lastname@example.org> wrote:
> I'd appreciate any troubleshooting tips for a suddenly non-turning
> G-1000DXA rotor. Cable continuity checks good, reading 500 ohms
> across the pot and 64 ohms across the motor back at the controller
> connector. If I hang a voltmeter across the motor pins (4,5) on the
> back of the controller with cable disconnected, I don't see any
> voltage generated by the controller when I press the LEFT/RIGHT turn
> buttons. Shouldn't I be seeing DC Voltage? If so, do I next check
> the fuse on the PS-Unit PCB or ???
> Any advice appreciated.
> Barry N1EU
TowerTalk mailing list