Hans is right, if the design calls for 5000 psi then it should be adhered
to. Crank-up tower foundations function more as ballast (to prevent
overturning) than as structural columns. Because of the massive size of the
foundations involved, the stresses developed in the foundation generally
aren't that great except in the area of the anchor bolts and to some degree
the shear loading at the upper exposed slab edges. Therefore, I'm not sure
you get much real benefit from the added compressive strength as long as you
develop the strength required for the anchor bolt design. US Towers usually
includes the anchor design numbers with the foundation calculations as well
as the overturning moment - it is sometimes insightful to know the
assumptions used in these calculations.
I don't know your climate but in South Texas we will sometimes (particularly
in the summer) see retardants and/or ice used in the high strength concrete
mixes because the high percentage of Portland creates a lot of heat in that
massive slab that builds up faster than it can dissipate. This sometimes
results in thermal stress cracking during the cure period. You may want to
consult with your batch plant about the logistics of deliver with respect to
placement and cure time. Some installers will also water cool their slabs
for the first few days - but this won't really do much for a tower base
because of the limited surface area. The slump (water content) of the mix
also affects the developed strength of the mix. Less water = more strength
but less workability. Also be aware that batch plants sometimes put some
rather generous safety factors into their mixes to mitigate their risk
exposure to rework back-charges from coming up short on strength (wrecking
out slabs is expensive). We have seen some 3000 psi mixes break at over
Hope this information is of use and I'm sure you will get a lot of good
input from others on the reflector.
73 & Hope you project goes well!
From: TowerTalk [mailto:firstname.lastname@example.org] On Behalf Of Rich
Hallman - N7TR
Sent: Monday, September 24, 2012 10:35 PM
Subject: [TowerTalk] 5000 psi vs 3500 psi concrete?
Im about to pour 16 yards of concrete for an HDX-689. Are there any real
benefits to using 5000 psi vs 3500 psi concrete?
ex KI3V, N3AMK, WB3JOV
Telnet: dxc.n7tr.com N7TR DXCluster
TowerTalk mailing list
No virus found in this message.
Checked by AVG - www.avg.com
Version: 2012.0.2221 / Virus Database: 2441/5290 - Release Date: 09/24/12
TowerTalk mailing list