Thanks for the reply. I get a lot of wind here and I'm afraid that the
counterweight would swing in the wind and cause stress on the rope/wire. I
wonder if there's a device that would retract the wire on a reel. Since I
retract my tower after I'm done with each operating session I need an automatic
device where I don't have to make a trip to the outside. I do have one of
those coax arm supports already on the mast.
My tower is also loaded to the max. so a rotatable dipole is out of the
question. My other options are to mount the apex at the top of the bottom
tower section, or to shunt feed the tower for 80m.
From: Larry Loen <email@example.com>
To: SPWoo <firstname.lastname@example.org>
Cc: "email@example.com" <firstname.lastname@example.org>
Sent: Saturday, October 6, 2012 1:58 PM
Subject: Re: [TowerTalk] Inverted V on a retractable tower
I have seen this very thing done.
Basically, you need some sort of extender (if you're talking about US Tower,
they sell such a device) so that the summit of the inverted V clears the tower
Then, you just need to have some sort of system at the ends of the antenna that
amount to some fairly simple pulley system with weights to allow the wires to
fall down when the tower is cranked over for service.
On a tower at W0IBM, I saw something like a commercial product that did this.
It was tubes of maybe 2 inches in diameter attached to courtyard walls (the
tower was in a courtyard). When the tower came down, the weight-and-rope at
the end of the wire antenna retracted into the tubes well enough. We could
detach or keep the thing intact from the top of the "V" when we tilted it
over. I believe we typically detached it for service; the system was designed
the wire was simply "where it needed to be" when the tower was retracted (but
not cranked over) so we could reattach it
after we cranked the tower back from horizontal to vertical.
At my forever under development new shack, I plan to do something similar with
my US Tower retractable. I have an old trick of putting conduit over rebar as
a distant antenna support for simple wire antennas. I'll probably resort to
the same weight-and-pulley trick -- I may even settle for a simple "eye hook"
instead of bothering with a pulley.
The nice thing about the rebar-covered-by-conduit is that while it is plenty
stable, it is easy enough to simply lift the conduit off of the end of the
rebar (the fit is tight, but not overly so). So, everything is serviceable.
With my simpler scheme, the wire may end up on the ground, but most of it would
be away from the tower and, I presume, easy to manage without kinking and
If I discover I can manage 20 feet of conduit with my scheme, then it is more
like the W0IBM installation, because it would be at about the same height as
the retracted tower.
On Sat, Oct 6, 2012 at 11:29 AM, SPWoo <email@example.com> wrote:
>Does anyone know how to install an inverted V antenna for 80m on a retractable
>tower? Is there anything that could be done to prevent the wires from laying
>on the ground when the tower is retracted? Thank you and 73.
>TowerTalk mailing list
TowerTalk mailing list