This is a great question that has been on my mind for a while. I was very
tempted to try to model it, but never found the time to do so. I also thought
that all I care about is the CW/RTTY portion of 80m.
That said, I decided to see what DX Engineering offers on their site for 80 m.
Two very interesting observations from the 80m vertical installation manual:
1) they use very small size tubing, not even close to what I am considering (my
current 40m vertical uses better tubing!!!)
2) they claim a very wide bandwidth
So if their 80m verticals are half as good as they claim, the much beefier size
tubing I am considering should do very well.
From: Jorge Diez - CX6VM <email@example.com>
To: 'Rudy Bakalov' <firstname.lastname@example.org>; TexasRF@aol.com;
Sent: Saturday, October 13, 2012 7:36 PM
Subject: RE: [TowerTalk] Choice of aluminum
What´s the bandwidth of this verticals compare with towers?
De: TowerTalk [mailto:email@example.com] En nombre de Rudy
Enviado el: sábado, 13 de octubre de 2012 21:04
Para: TexasRF@aol.com; firstname.lastname@example.org
Asunto: Re: [TowerTalk] Choice of aluminum
Thanks for the comprehensive answer. I didn't realize that 6061-T6 is more
expensive than 6063 as I was looking online prices in chunks of 12 and 24'.
Just for kicks I prices a 4-Square set of verticals made of 24' sections of
3", 2.5", and 2.0", 0.25" wall thickness. $2,300 delivered for the set.
Doesn't look that bad compared to dealing with towers and tower crews.
From: "TexasRF@aol.com" <TexasRF@aol.com>
To: email@example.com; firstname.lastname@example.org
Sent: Saturday, October 13, 2012 6:36 PM
Subject: Re: [TowerTalk] Choice of aluminum
Hi Rudy, 6061-T6 aluminum has a yield strength rating the same as 6063-T832
that is sold by Texas Towers and others.
The 6061-T6 costs more than 6063-T832 because of the extra
heating/quenching steps needed to reach the rated yield strength. 6063-T832
reaches the rated yield strength by work hardening the material in the
If you want a self supporting vertical, then you would need to go through
the same process as designing a 80 meter beam element with most of the
weight left out of the calculations. Just as a guess I would expect the
section to be about 4" diameter with a .25" wall.
This is not a trivial structure! Please proceed with caution!
If you want a guyed vertical, there are a number of them that have been on
the air long enough to think about duplicating one. W5UN is one that comes
In a message dated 10/13/2012 4:09:30 P.M. Central Daylight Time,
I was wondering if anyone can help me select the right material for
full-size 80m verticals. My questions are as follows:
>1) metalsupermarkets.com offers
6061-T6 aluminum, but not T8. Is there a difference between T6 and T8 for
>2) Should go for the 0.125 or 0.065 wall thickness?
>3) Is 1"
tubing OK for the topmost segment? Too stiff for the wind at 70'? Not
>I am aware that many ham stores offer 6061-T8 tubing, but I
do want to buy it local in VE3, close to my QTH, in 12' lengths (instead
6') and avoid shipping complications due to length or clearing
TowerTalk mailing list
TowerTalk mailing list