O.K. guys...here it is.......the link is http://photobucket.com/n4gnr
Now here is a breakdown of the pictures...One is the pulley I use-hanging
from a dogwood limb.
This pulley has no slop in it for any rope to jump the pulley. It is whisper
quiet. It is made by
Sherman and REilly, Chattanooga, Tenn,, has a 1250 lb rating, and is a
This pulley will swivel 360 unrestricted.
I have 2 pictures showing the bottom of the pole--showing the hooks. The
distance between the hooks
is 31 1/4 inches--thats the same distance between the angles of the tower
where the gin pole sits
when ready to use. It is critical that the hooks bottom out exactly the same
to eliminate free play. The
slots that make up the hooks need to be a couple inches off and away from
the gin pole to
give some clearance from the tower. 3 X 3 angle steel, or 4 X 4 angle steel
will do this just fine.
This pole can not jump off,, and in 25 yrs, never has. When under load, it
has NO lateral movement
at all. Under no load, it will wiggle side to side a little. Make the slots
for the hooks about 4 inches long,
and it will be very secure.
Since I have no tower up currently,, I tied off a section of Rohn 25 to
the balcony of the garage.
You can see the angles where the gin pole is mounted. I have a front and a
back view of this...
The good thing about this,, once you set up this gin pole to fit Rohn 25,,
it will also fit Rohn 45, 55,
and what is nicknamed Rohn 35( called HW for Motorola in the 60's)..It fits
them all. I have also
pulled up 300 ft runs of 7/8" heliax thru the pole-whichs weighs a lot more
than Rohn 55. I have
another one just like the one shown,, but it is about a foot longer. When
the gin pole is in
operating position,, there is 51 inches attached to the tower you are
climbing,, and about 10 ft
up in the air to raise or lower a section. Both my poles are 2 X 2 square,
and 1/4" wall. Hope
you all like this...It is a great gin pole-TRY IT !!! Dan Cisson N4GNR
----- Original Message -----
From: "Mike Lyon" <email@example.com>
Sent: Monday, October 15, 2012 4:59 PM
Subject: [TowerTalk] Tower removal. Gin Pole or something else?
So I have erected many towers using a standard 12 foot gin pole, works
great, but takes forever. However, what is the best practice these days
removing a 50-60 ft Rohn 25 tower? Gin pole or is there an easier way?
TowerTalk mailing list
TowerTalk mailing list