Towertalk
[Top] [All Lists]

Re: [TowerTalk] Climbing around Ring Rotors

To: K1TTT <k1ttt@arrl.net>, "towertalk@contesting.com" <towertalk@contesting.com>
Subject: Re: [TowerTalk] Climbing around Ring Rotors
From: Wayne Kline <w3ea@hotmail.com>
Date: Sun, 9 Dec 2012 11:48:41 -0500
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
One other tidbit,  When I climb over my Rings, I Do  just like Dave But I make 
sure the tower upright tube is in the center of my Body, make the ring closer 
to the tower and you have a larger Platform do plant your kneel or  plant you 
Foot on. Wayne W3EA  
 > From: K1TTT@ARRL.NET
> To: towertalk@contesting.com
> Date: Sun, 9 Dec 2012 15:48:17 +0000
> Subject: Re: [TowerTalk] Climbing around Ring Rotors
> 
> I've been doing it for years, it is annoying but not too hard to do.  I
> usually get up the the ring about shoulder high then clip to a rung above
> it.  Climb up  so its below my waist then either kneel on it with one leg
> and bring the other leg up to stand up on it, or just bring the first foot
> up to stand on it and stand up... depends on how heavy the toolbelt is and
> how flexible the clothes are.   with the snow suit the other day I had to
> kneel first then stand up, but usually with regular clothes I can just get a
> foot on it and stand up.  The bigger the ring of course the harder it is.
> It does pay to point the ring in a direction that puts the boom cradle away
> from the side you are planning to climb up so you have a nice clean platform
> to stand on.  And definitely make sure the power is off so no one can
> accidentally turn it on you.
> 
> 
> David Robbins K1TTT
> e-mail: mailto:k1ttt@arrl.net
> web: http://wiki.k1ttt.net
> AR-Cluster node: 145.69MHz or telnet://k1ttt.net
> 
> 
> -----Original Message-----
> From: Richard Thorne [mailto:rthorne@rthorne.net] 
> Sent: Sunday, December 09, 2012 15:33
> To: Towertalk
> Subject: [TowerTalk] Climbing around Ring Rotors
> 
> I'm working on a plan to install a couple Tic ring rotors on my 45g.  
> For the most part I've been using a crane for tower work. However, its more
> than likely I'll have to climb the tower occasionally.
> 
> Is it a major problem to climb around an installed Tic ring rotor?
> 
> Thanks
> 
> Rich - N5ZC
> _______________________________________________
> 
> 
> 
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
> 
> _______________________________________________
> 
> 
> 
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
                                          
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>