Thanks for the replies on this.
The manual that I mistakenly downloaded was for a 450 XL rotor which is
not the same as the 450 A. The 450 A manual directions are quite clear.
Thanks especially to TOM, W3RFG for clearing up the matter. -Thanks again
to all who replied. - Mike
-----Original Message-----
From: Mike Ryan
Sent: Wednesday, November 13, 2013 7:22 PM
To: towertalk@contesting.com
Subject: [TowerTalk] Yaesu 450A Rotor Wiring Question
The instructions for the 450 rotator show a six pin plug for the
control box and a SEVEN pin round connector that attaches to the actual
motor drive unit. The instructions further say NOT to use pin #1 on the
round connector. Does that mean that pin#1 on both the control box plug and
the round plug are not used? Does this rotor then just use only 5 wires to
operate? Am I missing something? How do the control box plug and the round
connector wire? - Mike
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|