Roger;
The answer to your original question is yes. Time to replace the cores.
Jack B, W6FB
On Jul 3, 2014, at 7:57 PM, Roger (K8RI) on TT <K8RI-on-TowerTalk@tm.net> wrote:
> On 7/3/2014 6:07 PM, larryjspammenot@teleport.com wrote:
>> Are these new ones that you're talking about the #31 mix material? Where are
>> you finding them for $5/each?
>
> Yes, they were new #31 mix. I purchased a 100 about 2 years ago and that was
> roughly $5., but close. I'd need to find the paperwork to even know where I
> purchased them after 2 years.
>
> 73
>
> Roger (K8RI)
>
>> LJ
>>
>>
>> -----Original Message-----
>>> From: "Roger (K8RI) on TT" <K8RI-on-TowerTalk@tm.net>
>>> Sent: Jul 1, 2014 5:25 PM
>>> To: "towertalk@contesting.com" <towertalk@contesting.com>
>>> Subject: [TowerTalk] Over heated cores
>>>
>>> I have several 2.4" OD cored. Will overheating cause their properties to
>>> change after they cool down I have 2 out of an AV640 that now have a
>>> dull surface. I have quite a few new ones, so replacing them is not a
>>> problem, but at near $5 each I'd like to save them if they are any
>>> good. The material is nor cracked/fractured.
>>>
>>> 73
>>>
>>> Roger (K8RI)
>>>
>>> _______________________________________________
>>>
>>>
>>>
>>> _______________________________________________
>>> TowerTalk mailing list
>>> TowerTalk@contesting.com
>>> http://lists.contesting.com/mailman/listinfo/towertalk
>> _______________________________________________
>>
>>
>>
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk@contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|