Bill,
Since the add on kit modifies the driven element, all you need to know is
the overall length of the modification, then take 1/2 that length and that
will be your new turning radius.
I found a manual for the 30m/40m add on kit for the A3S or A4S (not the
A3WS). I could not locate a manual for the A3WS, so this manual should give
you a pretty good idea. This manual lists the turning radius for either 30m
or 40m configuration as 15' 7" for the A3S and 18' 1" for the A4S.
http://www.cushcraftamateur.com/pdffiles/A743_451.pdf
Hope this helps.
Mitch KJ7JA
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|