Towertalk
[Top] [All Lists]

Re: [TowerTalk] Ham-IV Controller Interfcae to EA4TX ARS-USB

To: Ron 'KF5JRA' Rosson <kf5jra@oneinsane.org>, TT TowerTalk <towertalk@contesting.com>
Subject: Re: [TowerTalk] Ham-IV Controller Interfcae to EA4TX ARS-USB
From: Ken K6MR <k6mr@outlook.com>
Date: Thu, 8 Dec 2016 02:10:42 +0000
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
Not sure what you mean by EZ-Rotor making the Ham-IV controller unusable. It 
changes nothing in the operation of the controller other than allowing computer 
control. The manual controls remain unchanged.  I’ve got seven of them and they 
work great.



I’m not familiar with the ARS controller, but if it has relay outputs you 
should be able to wire it up to the Ham-IV. One of the relays (for the brake) 
has to be able to handle 120VAC (the brake circuit), the CW and CCW relays only 
need to handle 24VAC. If you have a schematic it should be easy.  If it just 
provides control outputs you’d need to build a relay control board, though you 
might be able to adapt the ERC relay board.



Ken K6MR



From: Ron 'KF5JRA' Rosson<mailto:kf5jra@oneinsane.org>
Sent: Wednesday, December 7, 2016 3:37 PM
To: TT TowerTalk<mailto:towertalk@contesting.com>
Subject: [TowerTalk] Ham-IV Controller Interfcae to EA4TX ARS-USB



Currently at my station I have a Ham-IV rotor turning my K4KIO Hex Beam with no 
issues other than having to reach and hold to get the antenna pointed where I 
my next contact is. On the shelf I have an EA4TX ARS-USB(w/24V wall-wart 
transformer) that was used by my previous failed Yaesu 450a rotor doing nothing.

What I am looking for is a way of hooking up the ARS-USB to the Ham-IV 
controller without ruining the Ham-IV controller. There is nothing wrong with 
it other than it does not provide a computer interface to my station for 
control.

What are my low cost options with what I have. I have looked at both EZ-Rotor 
and Idiom Press and both of those options make the Ham-IV controller unusable 
as well as cost money.

My end goal is to be able to have point and shoot from my station software as 
well as being able to control my rotor when not physically in the shack. 
(Remote operations are done with RS-BA1 to an IC-7300).

TIA
--
73 de KF5JRA
Ron


_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>