I actually make adaptor plates that bolt on the bottom of the Yaesu rotors, and
fit the classic T2X (or Ham IV) hole pattern. And yes, the Yaesu pattern is
Metric
--
73 de KG2V
Charlie
> On May 11, 2017, at 5:41 PM, KJ6Y--- via TowerTalk <towertalk@contesting.com>
> wrote:
>
>
> The Yaesu will fit. If you have the original rotator mounting plate,
> you'll have to drill new holes. The Yaesu holes are about a 1/4 inch
> further
> apart. Think metric. If it is a newer plate it may already have the holes
> for the Yaesu.
>
>
> Skip, KJ6Y
> Communications Service Co
> 818-522-5421 cell
> _www.kj6y.com_ (http://www.kj6y.com/)
>
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|