I used this exact procedure and it worked well. I had 4 runs of LMR-400-DB and
one of 1/2 inch heliax in 4" conduit.
Kim K5TU
Sent from Yahoo Mail on Android
On Mon, Aug 28, 2017 at 14:36, K7LXC--- via
TowerTalk<towertalk@contesting.com> wrote: > How about laying out the cables
in a bundle and then slipping each ten
foot abs piece over the end of the cables and slide it up to the previous
abs piece and glue them together one at a time. In that manner I would
not have to Pull heavy cable. I would have to watch the abs glue as it may
melt the cable coverings.
Yes, you would. Had a customer who did that very thing that resulted
in that particular run of cable was there permanently with no chance of
swapping it out.
Be careful. Be VERY careful!
Cheers,
Steve K7LXC
TOWER TECH
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|