Jim,
I think you got a rip off version of the Ancor brand, your Ankor is
Chinese is my guess. I've used up a 250' spool of what is marked RG8
and last measured the 165' length remaining was right on spec for loss
at 30MHz and even then it was 15 years old.
I've used a lot of Ancor products over the years and found them right on
spec, tinned conductors from 10 to 18ga, and the coax is exactly as
specified tinned center Cu and tinned shield and sturdy jacket.
And yes, RF stuff at Marine suppliers will empty your wallet vs
communications industry suppliers.
Grant KZ1W
On 9/24/2017 13:58 PM, Jim Brown wrote:
Several years ago, I did a friend a favor by providing guidance about
suppressing RFI to the HF installation on her sailboat. As you might
guess, I gave her a bunch of ferrite cores. In appreciation, she gave
me a short length (turned out to be 28 ft) of a so-called "Marine
Grade" coax with an Ankor brand. It had laid on a shelf outside the
shack until I picked it up a few days ago, put a connector on one end,
hooked it up to my VNWA, did a TDR sweep, made 5 MHz to 100 MHz
shorted and open impedance sweeps, and fed them to ZPlots to compute
Zo, VF, and attenuation.
Results were unimpressive, but unsurprising given a physical
examination of the cable. It's labeled RG213, has a flimsy outer
jacket that is easily nicked, a tinned copper braid that's also easily
nicked, and what appears to be a stranded copper-clad steel center!
Loss was 0.77dB/100 ft at 10 MHz, VF was 0.669. The outer jacket came
to me nicked in one place (a slice about 0.5 in long), and there was
obvious staining from corrosion of shield that lay beneath it.
The Ankor website describes their RG213 as having a "premium tinned
copper center conductor as well as a tinned copper outer braid for
corrosion resistance and easy soldering. It features signal loss
ratios of up to 50 percent less than other coaxial cables. 96 percent
braid provides best signal strength and least interference with UV
inhibited white jacket for longest life." The website contains no specs.
In fact, loss is significantly greater than ordinary good quality RG8
and RG213 from companies like Belden, Times, and Davis RF, and
physical properties are significantly worse. Amazon sells a 100 ft
length for $95. And they'll sell you Shakespeare-branded gold
PL259-knockoffs for $12.87 EACH! A gold plated barrel (also a
knock-off) will set you back $11.74. Compare with great coax like
Buryflex with AWG 9.5 stranded copper shield, foil plus tinned copper
braid shield, and really nice UV-resistant PE jacket. 100 ft costs you
$0.89/ft.
This marine stuff is on the level of the ultra-expensive but useless
stuff sold to high-futility folks!
73, Jim K9YC
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|