Hi Tom,
I am using aluminum straps for my grounding runs. I found 6" wide traps in the
garden department (don't remember what department store it was. Probably
Walmart). The strips are use as edging around flower bads. They were on sale as
it was the end of the season if i remember right. They came in rolls of 10 feet
and have some means to be connected together in longer runs (although I don't
think that connection is of any value from an electrical point).
I think it's a better idea to use aluminum as you are using an aluminum plate
at each end and there would be less issue regarding possible corrosion if you
use similar material in the plates and the grounding strip. Aluminum strips are
cheaper too, I believe.
Just my 10 cents,
Hans - N2JFS
-----Original Message-----
From: Tom_N2SR via TowerTalk <towertalk@contesting.com>
To: towertalk <towertalk@contesting.com>
Sent: Sun, Apr 22, 2018 1:37 pm
Subject: [TowerTalk] grounding (again)
Because of some new landscaping and the addition of a patio, I have to redo my
cable entry into the house/shack. I have a KF7P box mounted on the outside of
the cinder block foundation wall. It sits over a 2 inch hole which is sleeved
with grey PVC to get the cables through the wall (and into the shack). I have
2 hardine runs, plus two RG-8 (Davis RF Buryflex) runs, and 6 sprinkler system
cable runs from the base of the tower, which will terminate to Polyphasers
inside the KF7P box. In the KF7P box, I have an 0.25" aluminum plate to mount
the Polyphasers. The shack is on the other side of the foundation wall (from
the KF7P box). What I am planning to do is to add a 0.25" aluminum plate on
the inside (between the studs) in the shack. The plate will be about 12 inches
wide (the KF7P plate is ~ 12 inches wide)I want to tie the two plates together
with some copper strap. Any thoughts on the thickness of the strap? Georgia
Copper has 0.012", 0.022", and 0.032" thickne
ss. Are there other cheaper places to purchase copper strap? My
thought is to use 1 inch wide strap, and use as many straps as I can, across
the tops of both plates. Doing that, I'll have to make "flag" folds (triangle)
on several of the straps to get them to line up with the 2 inch PVC pipe, but I
don't think that will be an issue. I'm also going to tap holes in each plate
to attach the copper strap, and use stainless screws and flat washers. Do I
need Polyphasers on the plate in the shack? Thoughts, suggestions, ideas,
please. Tom,
N2SR______________________________________________________________________________________________TowerTalk
mailing
listTowerTalk@contesting.comhttp://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|