Towertalk
[Top] [All Lists]

Re: [TowerTalk] Solid 160 radial plates?

To: towertalk@contesting.com
Subject: Re: [TowerTalk] Solid 160 radial plates?
From: jimlux <jimlux@earthlink.net>
Date: Fri, 24 Aug 2018 08:10:03 -0700
List-post: <mailto:towertalk@contesting.com>
On 8/24/18 7:21 AM, Chick Allen via TowerTalk wrote:
I've been reading a lot of older threads about using ground shields (mesh or 
solid copper ground radial plates) at the base of an Inverted L for 160.  
Several contend that AM broadcast stations use copper shielding at the base 
feedpoint with radials attached around the perimeter as currents are max there. 
 Even the length of the radials becomes a question as one thread says the 
velocity factor of radials on the ground is 0.50 and the at the proper radial 
length, for on ground/slightly buried radials, is more like 80 feet and not one 
quarter wavelength.  Buried radials do not need to be resonant so my question 
centers more on the use of a solid, or mesh, material at the base.  Comments on 
this practice please?

The difference, if any, would be in the RF resistance of the plate, 
whether solid or mesh. I would think it wouldn't make a huge difference. 
 A mesh has more possibility of corrosion at the contact points in the 
weave.
One thing to think about is that skin depth in copper at 1.8 MHz is 
about 2 mils.  if you have a conductor thicker than 5-10 skin depths, 
there's not much current flowing in the middle of the conductor.
A 1/4" thick plate (250 mils) is really only carrying RF current in the 
outer 10 mils of each surface, so 92% of the copper is just there for 
structure and beauty.

For reference and comparison:
 10 mils is AWG 30, which is pretty fine wire.
1 oz copper clad is 1.4 mils thick.

- I'd worry about mechanical issues and how you're going to attach all those wires, more than whether it's solid or mesh. Copper sheet isn't much better than aluminum, from a resistance standpoint. However, with copper, you don't have the dissimilar metals issue, and you can solder to it with a (biggish) torch (it's hard to get a big sheet of copper hot)
Realistically, what might be easiest is just bundling bunches of the 
ground wires together, solder or braze them in a batch to something like 
a AWG 10-14 wire, then bunch all the big wires, and solder those.  This 
is something that is easily done with a propane torch, and while it 
won't be as pretty as a shining polished copper plate, its RF properties 
will probably be superior.

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>