Towertalk
[Top] [All Lists]

Re: [TowerTalk] US tower remote raising switch

To: "'VE6WZ_Steve'" <ve6wz@shaw.ca>, <towertalk@contesting.com>
Subject: Re: [TowerTalk] US tower remote raising switch
From: "Dick Green WC1M" <wc1m73@gmail.com>
Date: Mon, 7 Jan 2019 11:39:04 -0500
List-post: <mailto:towertalk@contesting.com>
Here's a link to my version, along with additional information/diagrams 
published by UST for the RMC-1000 tower and remote control circuits, and a 
photo of my 12V control box (unfortunately, I don't have a photo of the 12V 
interface at the tower):

https://drive.google.com/open?id=1wE6Tu_NyJ01y7JakWj3Az-WIAaA0ChA8

73, Dick WC1M

-----Original Message-----
From: VE6WZ_Steve <ve6wz@shaw.ca> 
Sent: Saturday, January 5, 2019 9:04 PM
To: towertalk@contesting.com
Subject: [TowerTalk] US tower remote raising switch

I have been archiving my station notes together into an electronic file so I 
can easily retrieve them when needed.
While uploading the files today I recalled a question here on tower talk about 
adding a remote UP-Down switch functionality to a US Tower, so I thought I 
would share this.

Here is a link to my documentation for a relay board I built which emulates the 
3PDT UP/DOWN switch which is used on the US tower HDX-589mpl Tower.
(A lot more “cost effective” than the US tower remote control box)

https://drive.google.com/file/d/1IuR1zBhKxquJhoyo6u2hkpHEf0PWsoqe/view?usp=sharing
 
<https://drive.google.com/file/d/1IuR1zBhKxquJhoyo6u2hkpHEf0PWsoqe/view?usp=sharing>

A +12v or -12V signal will drive the tower up or down while no voltage stops 
the tower.  Two 4PDT (LY4-DC-12) relays are mounted on an etched board and 
mounted inside the existing tower switch box.  Terminal blocks mounted on the 
board allow for a direct install using the same terminal lugs which attach to 
the existing switch screw terminals.  A schematic of the US tower switch box is 
included to identify the lug numbers, and a few photos of the installation.

This relay board has been in service for three years at the VE6WZ remote 
station and is configured to be remotely controlled either manually as 
required, or via a windspeed alarm which will automatically drive the tower 
down above a set windspeed.

73, de steve ve6wz.

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
<Prev in Thread] Current Thread [Next in Thread>