Towertalk
[Top] [All Lists]

Topband: In need of a Rohn 25 top plate

To: TowerTalk@contesting.com, topband@contesting.com, terry burge <ki7m@comcast.net>
Subject: Topband: In need of a Rohn 25 top plate
From: terry burge <ki7m@comcast.net>
Reply-to: terry burge <ki7m@comcast.net>
Date: Sat, 25 May 2019 13:47:10 -0700 (PDT)
List-post: <mailto:topband@contesting.com>
Hi folks,


I am in need of a Rohn 25 flat top plate or maybe a strong rotor/bearing plate. 
I've got to make a custom pulley and smaller return pulley setup for using my 
Ramsey worm gear winch to raise and lower a thousand pounds of tower from the 
ground up. Running the winch cable up the gin pole, out to a block-n-tackle on 
the tower, then back to the other side of the flat top plate is what I have in 
mind. I've done it before and it self aligns the tower great as well as 
dividing the load in half. My tower weighs just under 1000#'s and so whatever I 
come up has to be strong and may well require some welding and drilling. The 
top plate doesn't have to be pretty, just work.


Terry

KI7M

_________________
Searchable Archives: http://www.contesting.com/_topband - Topband Reflector

<Prev in Thread] Current Thread [Next in Thread>
  • Topband: In need of a Rohn 25 top plate, terry burge <=