I can't believe all this discussion about cutting 1/4" cable.
Just buy a cable cutter - small, cheap, and simple.
I have one and it cuts cleanly in one second. Probably could do 1/2".
73, Bob - W3YY
-----Original Message-----
From: TowerTalk [mailto:towertalk-bounces@contesting.com] On Behalf Of Richard
Blumenstein
Sent: Monday, June 29, 2020 10:22 AM
To: towertalk@contesting.com
Subject: Re: [TowerTalk] How best to cut 1/4 inch ss cable?
Phil-
I never tried it on ss cable, but if you have a Dremel tool, try cutting
it with one of their very thin cutoff wheels. I have a feeling that
might work. I have easily cut off 1/8" nails coming out of a board whose
other side I could not get to in order to remove it.
Dick, K0CAT
=================================
Phil wrote on 6/27/2020 3:08 PM:
> Any recommendations? I was thinking about taping
> the place for the cut with electrical tape and then
> wedging it in a piece of copper tubing....
>
> thanks, 73, Phil W5BVB
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
//
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|