I am set to 4800 with 2 stop bits. I am using a fully wired cable.
It fails if I wire it the way the documentation talks about. I must us a
fully wired cable because I also use it with Logic 5 and other programs that
require fully wired cables.
I realize this makes it impossible to use the serial port for push to talk
but I think that is not good practice to use the same port in any case. I
use my other port for push to talk with other programs and I use VOX with
> -----Original Message-----
> From: George Fremin III [mailto:firstname.lastname@example.org]
> Sent: Thursday, December 16, 1999 2:58 PM
> To: Gil Baron W0MN
> Subject: Re: [TRLog] TS-870
> Gil Baron W0MN writes:
> > George;
> > I have an 870 and interface it with very little problem.
> > Sometimes it seems that it might be nicer if it were a faster
> response to
> > frequency change but that is the polling he does so doubt can
> do anything.
> > It takes about 3/4th second usually, not all that bad.
> > I am using a very simple interface, just as shown in the
> documents and no
> > optical or anything.
> What baud rate do you have it set for - what menu setting?
> Are you usign a fully wired cable.
> George Fremin III "I'm talkin' 'bout that outlaw X
> Johnson City, TX It's cuttin' through the air.... "
> K5TR (ex.WB5VZL)
> 830/868-2510 -- "Heard it on the X"
> email@example.com -- ZZ Top
FAQ on WWW: http://www.contesting.com/trlogfaq.html
Administrative requests: trlog-REQUEST@contesting.com
Feature Wishlist: http://web.jzap.com/n6tr/trwish.html