WriteLog
[Top] [All Lists]

[WriteLog] Writelog and Japan Radio JST-245 HELP Update

To: <writelog@contesting.com>
Subject: [WriteLog] Writelog and Japan Radio JST-245 HELP Update
From: W0AH@aol.com (W0AH@aol.com)
Date: Wed, 22 Nov 2000 18:21:18 EST
Thanks for the several replies which suggested, if this dummy understood them-
1)  That the DB25M to DB25M was the wrong cable.  
But as quoted in my original post- the JST-245 manual says to connect with 
such a cable.  The cable would therefore connect from the parallel port of my 
Fujitsu laptop to the RS-232C on the back of my JST-245 transceiver.  
BTW, I also have a DB-9M serial jack on the rear of my laptop and a DB-9F to 
DB-25M cable I could use, if called for.  Are both these cables called 
RS-232C cables????
2) To check the DB25M to DB-25M cable for continuity on all 25 lines.
  I did that and the cable's  OK.
3)  The following was suggested-
"Some radios require that you jumper pins (1 to 6) and (4 to 7) on the radio 
end of the cable.
BTW that is for a DB-9. For a DB-25 its  (4 to 5)   &   (6 to 8).
AND/OR
It may or may not be necessary to reverse the wires on pins 2&3 (DB-9 or 25).
I'd try reversing 2&3 first though. Easier."
None of the above seems easy without a breakout box which I do not have.  I 
have not attempted the above.
4) The following was suggested-
"There IS a section in the ini file where the com port parameters are
specified - Make sure these are correct for your radio control, e.g.
9600-n-8-1 or whatever is CORRECT for your radio.  These settings apparently
override the Windows Device Manager settings, so they ARE important.  The
COM paarameters SHOULD be in your rig's user manual."

--
WWW:                      http://www.writelog.com/
Submissions:              writelog@contesting.com
Administrative requests:  writelog-REQUEST@contesting.com
Problems:                 owner-writelog@contesting.com


<Prev in Thread] Current Thread [Next in Thread>
  • [WriteLog] Writelog and Japan Radio JST-245 HELP Update, W0AH@aol.com <=