WriteLog
[Top] [All Lists]

Re: [WriteLog] writelog + Orion

To: "Bernd DC3HB" <dc3hb@freenet.de>
Subject: Re: [WriteLog] writelog + Orion
From: "Wayne Wright, W5XD" <w5xd@writelog.com>
Reply-to: w5xd@writelog.com
Date: Tue, 6 Sep 2005 18:11:24 -0500 (CDT)
List-post: <mailto:writelog@contesting.com>
Search the WriteLog help file for "Orion" and you will find WL already
has implemented this. You will need to change WRITELOG.INI this way:
[RIGS]
OrionRITClearHz=1

> Hi Pat,
>
> thank's for your answer. I will post this in the reflector.
>
> Wayne, can you implement this?
>
> 73 de Bernd, DC3HB
>
>   ----- Original Message -----
>   From: Howard Patterson
>   To: dc3hb@freenet.de
>   Sent: Tuesday, September 06, 2005 8:31 AM
>   Subject: Orion RIT with WriteLog
>
>
>   Hi Bernd,
>
>   I don't know how Wayne, W5XD implements the %O macro but I'm guessing he
> is sending the string *RMR0<cr> to the Orion to set the RIT to zero
> offset.  When that command is sent to the Orion it actually turns RIT
> off.  I suppose that is the most direct way to set it to "0"! If you
> alter the command to show 1 Hz of offset (*RMR1<cr>) RIT is not turned
> off.  I think Carl, N4PY uses this scheme in is Ten Tec rig control
> software.  He implements a "set RIT to zero" by actually setting it to 1
> or 2 Hz offset.  What's a couple of Hertz between friends!  He uses the
> *RMR0<cr> to actually turn RIT off. There is no RIT On/Off command.
> Perhaps Wayne could do the same in WriteLog?  I used HyperTerminal to
> "connect" to the Orion com port to test this.
>
>
>
>   I sent this to the reflector yesterday but it hasn't appeared.  I just
> enrolled so perhaps I'm not authorized to post yet.
>
>
>
>   73,
>
>   Pat, W5VY
>
>   North Little Rock, AR
>
>   ppattrsn@swbell.net
>
>
>
>   -----Original Message-----
>   From: writelog-bounces@contesting.com
>   [mailto:writelog-bounces@contesting.com] On Behalf Of Bernd DC3HB
>   Sent: Saturday, September 03, 2005 12:16 PM
>   To: writelog@contesting.com
>   Subject: [WriteLog] writelog + Orion
>
>   Hello folks,
>
>   I use the macro %O in a buffer. Everything works at my YAESU FT-1000
> very
>   well.
>
>   But there are problems at my Ten Tec Orion. The RIT is backed zero but
> the
>   RIT switched off simultaneously. Can switching off be prevented? Any
> ideas?
>
>   73 de Bernd, DC3HB
>
>


_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web:  http://www.writelog.com/

<Prev in Thread] Current Thread [Next in Thread>