[Top] [All Lists]

[Yaesu] VOX on FT-101ZD

To: <yaesu@contesting.com>
Subject: [Yaesu] VOX on FT-101ZD
From: KA2YKC@aol.com (KA2YKC)
Date: Tue, 5 May 1998 22:03:59 EDT
In a message dated 98-05-05 20:14:17 EDT, thommo@caribsurf.com writes:

<< Hi,
 A friend of mine has a problem with the VOX on his FT-101ZD.
 He says when he follows the instructions in the Service Manual
 explaining the vox it (vox) does not work. However, when he uses the 
 microphone as normal and releases the key the vox delay works. 
 Any soloutions would be appreciated.
 Stephen, 8P6CV

Remember, the VOX circuit needs the audio line to be hot at all times. Most
microphones, with the exception of the factory Icom, Yaesu, and Kenwood mics,
switch off the audio line during rx. Check the microphone he/she is using and
wire the audio line hot at all times (simply jumper the PTT contacts inside). 

On some Shure mics (444, 444D), there was a switch on the bottom that broke
the tx lead when engaged in "VOX" position. THen you simply lock the PTT
button, and the audio line feeds the transceiver at all times, but the mic PTT
is inactive. Then switch the rig to vox mode.

Good Luck
73 Eric KK2ED

FAQ on WWW:               http://www.qsl.net/k7on/yaesu.html
Submissions:              yaesu@contesting.com
Administrative requests:  yaesu-REQUEST@contesting.com
Problems:                 owner-yaesu@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm

<Prev in Thread] Current Thread [Next in Thread>