I found my problem...the case of my PC has mis labeled the com ports...when I
switched to the alternate port works fine...make sure you check the PC board for
which port is com 1....
> What is the version level of the FT1kD EPROM ?
> I understand that prior to vers 6 there was a problem with CAT with FT1k. I
> t run CAT myself, but recently did research the Archive reflector postings on
> this topic.
> 73s, de ~ Vince ~
> "Jim White, K4OJ" wrote:
> > ...once againj this QCAO asks for assistance...
> > new contest radio this year - FT1000....new interface to computer purchased
> > (W1GEE plug n play)....
> > Well not exactly...
> > Plugged in the interface and turned on NA, told NA in config it was an
> > FT1000, told it to look at the comm port....but nil.
> > There does NOT appear to be talking going on between the two of them...if I
> > type a frequency on the keyboard and hit enter the rig does not QSY
> > there...if I change bands on the rig the software does not follow...
> > If you have this combination of hardware and have exeperienced this and have
> > h&k it would be appreciated...less than a week til Sweepstakes!
> > 73,
> > Jim, K4OJ
> Yaesu mailing list