Replacement batt. Was that a good one ?
Be aware when manipulating these back-up batt. a short C/C and its gone.
Did you put the batt. in place with the right polarity.
Could there be a rom device that must be reprogrammed......
Good luck
73 Jos on4kj
----- Original Message -----
From: "Bruce & Carrie Claggett" <kb4zax@arrl.net>
To: <yaesu@contesting.com>
Sent: Saturday, May 03, 2003 12:11 AM
Subject: [Yaesu] FT2400 locked up
> I pulled my FT-2400 out of my truck when I got ready to trade trucks.
> Well I let it set on shelf for 6 plus months and decided to hook it back
up.
>
> When I applied power the read only shows 28.000.
> I can not get frequency to move.
>
> Hold D/MR and REV button down while turning and
> read out goes from 28.00 to 320.00 in 100 steps and the 1
> in memory box is flashing. No "key up".
> Turn rig off back on it goes back to 28.000.
>
> Called Yaesu and "without liking at it" they thought the battery back-up
had
> gone bad.
> Replaced battery but still same.
>
> As anyone got any ideas ??
>
> Thanks in advance,
> BRUCE CLAGGETT
> KB4ZAX / AFA2XQ / KY
>
> _______________________________________________
> Yaesu mailing list
> Yaesu@contesting.com
> http://lists.contesting.com/mailman/listinfo/yaesu
>
|