I have been using the following setting since 2001
with a Yaesu FT-1000MP and have received regular
compliments on my audio with the Heil ProSet and
the DX element. My source for this was a website
that no longer exists, but credit was given to the
Chiltern DX Club, Yaesu UK and N1EU. I hope they
work for you.
4.4 TX EDSP Change from "off" to "3".
7.7 EDSP Modulation Change to "100-3100" for ragchew, and 2800 for DX.
These are the major two transmit settings. I *never* use the voice processor.
Check out http://n1eu.tripod.com/
and especially http://www.va3cr.net/
There are other eDSP settings for receive, and I'm very pleased
with the results, especially on CW. Let me know if you can't locate
them on the va3cr site.
Also, my radio is currently being repaired for a sub-receiver problem,
but it will have the INRAD Roofing Filter installed after the repair. This
will make a huge difference for those operating in the crowded conditions
you might have in EU, so I'd be happy to advise how that works in a couple
At 07:06 AM 10/24/2004, Massimo Taddei wrote:
I would appreciate .
So I an do some testing.
----- Original Message -----
From: "ARS NZ3O (Byron) FM29fx" <NZ3O@ARRL.NET>
Sent: Sunday, October 24, 2004 12:42 AM
Subject: Heil es Yaesu settings
> I have an FT-1000MP with the DX4 element. Would
> you be interested in the settings I use; I'm not sure they
> are the same options available in the Mk V.
> 73, Byron
Yaesu mailing list