In the menu settings for the FT-1000MP and the Mark V radios, there is a way to
disable the Sub-Receiver. If you were working through the menu list you may
have inadvertently shut down that part of the radio. Check menu item 7-8 (on
the 200 watt Mark V).
-------------- Original message from "Patrick W7TMT" <email@example.com>:
> Just picked up a new FT-1000MP Mark V Field and before I take it back to the
> dealer I thought I'd see if the knowledgeable folks on the list had any
> suggestions for this problem.
> Brand new out-of-the-box radio. No extra filters added yet (I have an order
> in the pipe-line to InRad). When I first turned the radio on the
> sub-receiver appeared to work as expected. After about a half hour of
> reading through the manual and looking at the various settings etc. and
> tuning around the bands checking out the receive functions the sub-receiver
> suddenly quit working. Never even put the radio into the transmit mode I was
> just listening to the receiver and trying out the various EDSP and filter
> settings. Audio is there and lots of background noise, in fact much more
> than in the main receiver, but no signals are received. Since then I have
> verified that VFO can be used to control the transmit freq. but the receiver
> is gone. I have already done a total CPU reset per the manual (twice) to no
> avail. Any ideas other than me boxing it up and taking it back. Fortunately
> the store is within driving distance (if you consider a couple of hours
> "within driving distance").
> Thanks for your assistance.
> Yaesu mailing list
Yaesu mailing list