[Yaesu] Idiom Press interface

[Mike <nf4l@nf4l.com>]

I have an Idiom Press interface for my G-1000DXA rotor. When I turn the 
beam to the stop in the overlap region (ca 265 degrees), the left right 
manual paddle become inoperative, and I have to use the computer to turn 
back. Going to the same point manually, the paddle works normally.

Any one else experienced this, or know what the cause/cure is?

73, Mike NF4L

_______________________________________________
Yaesu mailing list
Yaesu@contesting.com
http://lists.contesting.com/mailman/listinfo/yaesu