[Top] [All Lists]

[Yaesu] Filters Speaker, HF Rig, Mics and more FS

To: Yaesu at contesting <yaesu@contesting.com>
Subject: [Yaesu] Filters Speaker, HF Rig, Mics and more FS
From: "Ken Simpson, W8EK" <W8EK@flham.net>
Date: Sat, 29 Oct 2011 10:08:17 -0400
List-post: <yaesu@contesting.com">mailto:yaesu@contesting.com>
Yaesu Items For Sale  --  Filtered speaker, HF transceiver,
microphones, cables, HT accessories, and more

Yaesu SP-6 Speaker with phone patch and Filters:

This Yaesu SP-6 speaker has the phone patch and filters in it.
It is the matching speaker for the Yaesu FT-990 and many others.
It permits one to switch between two different rigs, and has
adjustable filters on both the high and low end to permit one
to get rid of QRM, and have a great sound.

This one is in extremely nice condition and works 100%. Not
a single scratch or mark on it. You will not find a nicer one
unless it just came out of the box.

With paper work for $150.

Heath SB1400 HF Transceiver (similar to Yaesu FT-747):

This is a 100 watt multimode HF transceiver covering 160 to
10 meters (including WARC bands). It operates on SSB, CW,and
AM. The receiver is very sensitive. This rig has noise blanker,
squelch, adjustable AGC and attenuator, as well as memories
and two VFOs. A narrow CW filter is included. It even has a
computer interface and is very similar to the Yaesu FT-747.

This one works 100% and looks very, very nice.
It includes power cord and paper work for $300.

Heath SB-1400-2 hand microphone
This hand mic is basically the same as a Yaesu MH-1, but with a
Heath label. Use it with the SB-1400 above, or with Yeasu rigs
with the round 8 pin connector. Like new for $40.

Heil HM-10 Deluxe Microphone:

The Heil HM-10-5 is a beautiful microphone resembling the
"gold line series". It has the HM-5 wide element for good
frequency response, and good articulation.
This particular microphone looks very close to new.
It includes paper work in its original fancy Heil box. $75

Cables for Heil (and other) Microphones:

Heil CC-1 Y  cable for Yaesu (yellow)
Connects to Heil mics with the 4 pin XLR connector (most
Heil mics), and has a round 8 pin connector wired for Yaesu,
plus a jack for PTT. $25

Hand held PTT switch
The Heil Microphones require a separate PTT switch -- either a
hand switch or a foot switch.  This is a home made hand switch.
It is similar to the Heil, except it is in a 1 x 1 x 2 inch
minibox, with about a 3 foot cord.  It works and looks fine.

Heil CC-1 XLR 4
4 pin XLR Female to 3 pin XLR Male $25

3 pin XLR to stripped ends
About 10 feet of quality rubber covered mic cable with a 3 pin
XLR connector on one end. Ideal to add your own connector.
Can be used with the CC-1 XLR-4 above. $20

Microphone Stands:

Heil SB-2 small boom
The Heil Sound SB-2 Small Boom is ideal for mounting your
Heil microphone.
The SB-2 includes the 'stealth' C-Clamp.
This one is in extremely nice condition. $50

Regular round desk stand
Round 6 inch diameter heavy black / dark grey base, with
a 3 inch chrome tube coming up from the middle.
Standard 5/8 inch threaded. $15

Microphone holders:

Heil Mic Holder
Black plastic holder, for 1 inch diameter mics.
Standard 5/8 inch threads. $8

Electro Voice Mic Holder
Gray colored EV, designed to hold 5/8 to 3/4 inch diameter mics,
and go into a stand with standard 5/8 inch threads. $5

Chrome Mic holder
Similar to EV holder, but chrome metal with a green felt on the
inside to protect the mic. For 1/2 inch to 5/8 inch diameter
microphones. Standard 5/8 inch threads. $5

Heil Wind Screen
This windscreen can be used with a variety of microphones,
including the HM-10. Excellent condition. $8

Yaesu MH-1 Hand Microphone:

The Yaesu MH-1 b8 is the hand mic that is used on most of
the Yaesu HF and some of the Yaesu VHF rigs. It is a hand
mic that has a switch on the back with two audio frequency
responses -- one for rag chewing, and one for more punch
for DX. It has up and down switches, in addition to a
"fast" switch. Of course it also has the normal PTT
switch. It has a round 8 pin mic connector, wired for

This particular microphone looks like it might not have
ever been used. I think it was probably put in a drawer
when new, and left there. Of course it works fine. $38

Yaesu MH-31 B 8 dynamic hand microphone:

This is the Yaesu hand microphone that has the round 8
pin connector on it.  It will go with virtually any Yaesu
rig that uses the round 8 pin connector.  It has up, down,
and fst switches, and well as a tone switch, in addition
to the PTT switch.
This particular unit works 100%, and appears to be unused.

Yaesu YM-22 DTMF Condenser Microphone
This mic has a 16 digit touch tone (DTMF) pad on the front.
There are up and down buttons on the top, in addition to
the PTT switch.
Stripped and tinned ends. Great condition.  $40

Speaker Microphones:

Yaesu MH-34 b 4 b speaker microphone
This is the one that fits the Yaesu VX-8, VX-7, VX-6,
VX-5, VX-3, VX-2, VX-1, and that series of HTs. I
think it also fits the FT-50 and FT-60, and maybe
others. It has a single 4 conductor, 3.5 mm plug on
it. This one is just like new. $35

Yaesu YM-24 A speaker mic.
Fits FT-207, 208, plus many others. It has the odd
little round connector on it like Yaesu, Wilson, and
others used in the 1970s and 80s. This particular unit
works fine, and looks great also. $20

Pryme Speaker Microphone
This is the equivalent of the Yaesu MH-34 (above).  It
has the 4 conductor 1/8 inch plug on it.  It works 100%
and looks like it has not been used.  $28

Azden SDX-316
This is the rounder style speaker mic that fits nicely in
the palm of your hand. Has 3.5 mm and 2.5 mm plugs for
Azden, Icom, some Yaesu, and others. $ 20

Pryme Speaker Microphone
This speaker mic has the 2.5 mm and 3.5 mm molded connector
as used by Icom, Alinco, Radio Shack, some Yaesu, and others.
It works fine and look line new.  $20

MFJ-287 Speaker Microphone
This fits the TH-21/31/41 series HTs, TH-205, TH-215, TH-415,
as well as others. It has a 3 conductor 3.5 mm plug and a 2
conductor 2.5 mm plug.
It works fine, and looks close to new. $15

Yaesu HT Accessory Items:

Battery pack for Yaesu VX-2 or VX-3 HT
Lithium Ion Battery Pack fits both the VX-2 and the
VX-3. 3.7 volts, 1200 mahr, works great, and holds a charge
like new. $15

Yaesu NC-18 B Charger
Provides 14.5 V DC at 50 ma to charge many different HTs,
including the Yaesu FT-411, FT-811, FT-911, FT-23, FT-209,
FT-415, FT-410, FT-470, FT-727, FT-530, FT-703, and more.
Small 2.5 mm male plug. $10

Belt Clip for Yaesu FT-207, with hardware. $8

Wrist Strap for Yaesu FT-209, and probably others $4

Prices do not include shipping from Florida.

I also have many other accessories available such as many
different types of HTs, VHF and UHF rigs, HF and VHF/UHF
antennas, etc.
Just too many to list here. Please e-mail your requests.



Ken, W8EK

Ken Simpson
E-mail to W8EK@FLHam.net or W8EK@arrl.net
Voice Phone  (352) 732-8400

Yaesu mailing list

<Prev in Thread] Current Thread [Next in Thread>
  • [Yaesu] Filters Speaker, HF Rig, Mics and more FS, Ken Simpson, W8EK <=