> I have been having a problem with my FT-847 transceiver output power being
> folded back when driving a SB-220 in SSB mode due to erratic SB-220 input
> SWR. The input SWR of the amplifier is varying between 1:1 and 5:1. As the
> SWR increases, the power of the transceiver reduces due to the automatic
> fold back circuits and therefore amplifier output power reduces accordingly.
> If the transceiver is set to CW then SWR is 1.2:1 and amplifier produces
> full output.
>
> My previous TS-830S exciter always produced correct output ... but it didn't
> have any fold back circuits either.
>
> Is this a normal situation using solid state exciters?
Is this happening on all bands?
If only one band, you have probably toasted the mica caps on the input Pi
matching network. I have also seen an input coil melt down in some cases.
Further info needed to make more suggestions.
GL!
Phil, K5PC
--
FAQ on WWW: http://www.contesting.com/FAQ/amps
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
|