Sounds like a sticking relay.
Perhaps you hear the coil and some of the contacts
drop out, but not all of them.
GL!
Phil, K5PC
> Just developed a problem in my AL-80B, and not sure what's going on. When
> operating SSB or CW, all is well and has been since I got the amp last year.
> I'm getting back on RTTY and was running some tests with the new transceiver
> when I noticed this problem.
>
> I key the TS-950SDX in FSK mode with about 40 watts output, driving the
> AL-80B to about 400 watts out on 14.080 into a dummy load. If I unkey the
> transceiver within a few seconds, everything returns to normal in receive
> mode. However, if I leave carrier on for 15 seconds or so and then return
> to receive, I hear the relay drop in the linear, but I still have 100ma. of
> plate current and a resulting orange glow on the plate. Turning the XMT
> switch on the AL-80B to STBY makes no difference. I have to turn off the
> linear in order to get things back to normal. Perhaps a failure in the
> AL-80B bias circuit? ALC voltage is set correctly, and grid and plate
> current are normal with key down just before the failure.
>
> K8AC
> Floyd Sense - Angier, NC
>
>
> --
> FAQ on WWW: http://www.contesting.com/FAQ/amps
> Submissions: amps@contesting.com
> Administrative requests: amps-REQUEST@contesting.com
> Problems: owner-amps@contesting.com
>
>
--
FAQ on WWW: http://www.contesting.com/FAQ/amps
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
|