Would not loading heavier cause the grid current to be even higher?Jim..
----- Original Message -----
From: <TexasRF@aol.com>
To: <Paul@PaulFerguson.us>; <amps@contesting.com>
Sent: Saturday, April 14, 2007 9:28 AM
Subject: Re: [Amps] HF-2000 amp problem?
>
> Sounds like you need to increase the drive to 50-75w like 20m and load
> heavier (less load C) for maximum output.
>
> If this scares you, load heavier first and then increase the drive power.
>
> 73,
> Gerald K5GW
>
> In a message dated 4/14/2007 10:25:05 A.M. Central Daylight Time,
> Paul@PaulFerguson.us writes:
>
> I have a 10-year-old QRO HF-2000 amp. It has two Amperex 3-500Z
> tubes. You can see info on it at: http://www.qrotec.com/
>
> It used to output 1,000 watts or so on all bands. Now it outputs
> 1,000 watts up to 20 meters, but only about 500 watts on 17 meters
> thru 10 meters.
>
> On 20 meters and lower, grid current runs about 150 ma and plate
> current about 500 ma. Plate voltage is about 2,800. Input power runs
> 50 - 75 watts.
>
> On 17 meters and higher, grid current is about 100 - 150 ma and plate
> current is 250 - 300 ma. A small increase in input power gives a
> large increase in grid current and little additional output power.
> Input power is 30 - 40 watts.
>
> The amps tuned inputs seem OK as the transceiver sees an SWR of 1.1 -
> 1.3.
>
> All measurements were taken using a 50 ohm dummy load.
>
> Any ideas as to what might be the problem?
>
> 73,
> Paul - K5ESW
> Raleigh, NC
>
>
>
>
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>
>
>
>
>
>
> ************************************** See what's free at
http://www.aol.com.
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|