I have my homebrew amp project ready for the sheet metal order. I already have
a .125" thick aluminum front rack panel. But how heavy should I go on the
remaining panels? I will have 2 side panels, a deck, an interior front panel
(the real "front" of the rf compartment. The other front panel will sit a few
inches in front allowing space for meters and such), then of course top, bottom
and rear panels. I will hold everything together with half-inch aluminum angle
stock. I am thinking .068 to .075" thick for the deck and sides, then .050"
for top, bottom, back.
Steve KK7UV
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|