The tubes will do fine with 2.6KV but the problem will be to get the tubes
matched to a quad, those tubes vary quite a bit.
I needed 8 tubes to find 2 almost equal.
To raise the C1 capacitance I would raise the circuit Q to 15 then it will
be no problem with the harmonics, but Pi-L at 490 Ohms needs C1 of about
80pf at Q=12, which should be no problem either.
73
Peter
-----Original Message-----
From: amps-bounces@contesting.com [mailto:amps-bounces@contesting.com] On
Behalf Of Leigh S. Jones, KR6X
Sent: Freitag, 26. Mai 2006 05:39
To: amps@contesting.com
Subject: Re: [Amps] Quad Tube 4cx800 hf amp
http://www.tomstubes.com/4CX800A.htm for a data sheet
You've got some problems. First of all, the tube is good for 2 KV DC and
pushing it to 2.6 KV would not be recommended. Secondly, the output
capacitance is not nearly as high as you imagine (9-13 pf). Your design
needs to be for a lower plate impedence if you stick to the 4 tube formula.
2.0 KV at 3.0 A peak. If you need to push it, you could use a Pi network
output circuit in lieu of a Pi-L network to raise the C1 capacitance on 10
meters. Then you would use a high quality low pass filter to reduce the
harmonics. Frankly, I don't think you should need to do that; the 4CX800
should be easy to run on 10 meters in pairs or quads. But I recommend the
pair.
----- Original Message -----
From: "Manuel R. Alonso / KC4MNE" <kc4mne@bellsouth.net>
To: <amps@contesting.com>
Sent: Thursday, May 25, 2006 6:50 PM
Subject: [Amps] Quad Tube 4cx800 hf amp
> Hello
>
> Would it be feasable to build a 4 tube amplifier using the 4cx800 russian
> tubes.
>
> I calculated a plate impeadance of about 490 ohms, using (2600V 3.0 amp
> supply)
>
> However for a Pi output I am looking at a c1 value of about 100 pf at
> 29MHZ and each tube has 51pf of capacitance already, if added together
> thats over 200pf. How is this obstacle corrected?
>
> Manny
>
> KC4MNE
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|