I get a big chuckle almost every day on E-Bay with people bidding
outlandish prices for the Millen connectors, and of course, Surplus
Sales of NE is always "retail + 100%" on a lot of their stuff.
Bulletin! Bulletin!
The James Millen Co. is alive and well in North Andover, MA!!!!!
Tel. number for the hardware division is (781)662-8939
A complete set of either red or black connectors is under $8.00!!!!
The Millen red and black connectors must be in daily use on 1000's
of amps around the world. There is a mounting scheme to use if going
above 4000 volts that makes them as good as anything else. Most
of my failures with Millen connectors were self-induced > 2 amps/not
mounting on plexiglass or teflon/chassis hole too small. These connectors
allow use of copper spark plug wire from J.C. Whitney in Chicago. This
stuff must be good for 30-40kv and it fits snuggly into the male connector.
It has been charged that the Millen connectors are hygroscopic. The yellow
ones are, but the red and black are not. The yellow ones were for "other
than D.C." applications. You will do very well to out-live a Millen connector
unless you step on it or mount it directly to metal.>(4kv)
The Amphenol connectors are great, but Teflon coax is not very flexible.
(((73)))
Phil, K5PC
Phil Clements
410 VZ CR 4903
Ben Wheeler, TX 75754
----- Original Message -----
From: Mike Sawyer <kc4slk@csrlink.net>
To: Mike Blier <w6ffc@pacbell.net>; George McCrary <geo@ipass.net>;
<amps@contesting.com>
Sent: Tuesday, April 18, 2000 3:44 PM
Subject: Re: [AMPS] High Voltage Connectors?
>
> I remember these were discussed here not too long ago. It seems that they
> were only good to about 2KV.
> Mike(y)
> W3SLK
> ----- Original Message -----
> From: Mike Blier <w6ffc@pacbell.net>
> To: George McCrary <geo@ipass.net>; <amps@contesting.com>
> Sent: Tuesday, April 18, 2000 12:32 PM
> Subject: Re: [AMPS] High Voltage Connectors?
>
>
> >
> > Here ya go. These are the "Standard" HV connectors..
> >
> > http://www.surplussales.com/Wire-Cable/HVWire-2.html
> >
> > Mike W6FFC
> >
> > ----- Original Message -----
> > From: George McCrary <geo@ipass.net>
> > To: <amps@contesting.com>
> > Sent: Tuesday, April 18, 2000 8:46 AM
> > Subject: [AMPS] High Voltage Connectors?
> >
> >
> > >
> > > Hello,
> > >
> > > I would appreciate some advice on what connectors would be
> > > suitable to use on the cable connecting a high voltage supply (approx
> > > 3 kV) to an rf deck.
> > >
> > > Also any information about a good source for said connectors
> > > would be helpful.
> > >
> > >
> > > Regards,
> > >
> > > George (KQ4QM)
> > >
> > > --
> > > FAQ on WWW: http://www.contesting.com/ampsfaq.html
> > > Submissions: amps@contesting.com
> > > Administrative requests: amps-REQUEST@contesting.com
> > > Problems: owner-amps@contesting.com
> > > Search: http://www.contesting.com/km9p/search.htm
> > >
> >
> >
> > --
> > FAQ on WWW: http://www.contesting.com/ampsfaq.html
> > Submissions: amps@contesting.com
> > Administrative requests: amps-REQUEST@contesting.com
> > Problems: owner-amps@contesting.com
> > Search: http://www.contesting.com/km9p/search.htm
> >
>
>
> --
> FAQ on WWW: http://www.contesting.com/ampsfaq.html
> Submissions: amps@contesting.com
> Administrative requests: amps-REQUEST@contesting.com
> Problems: owner-amps@contesting.com
> Search: http://www.contesting.com/km9p/search.htm
>
--
FAQ on WWW: http://www.contesting.com/ampsfaq.html
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|