> Can anybody tell me why I shouldn't do this?
George, it should work just fine and that looks like a good substitute for
the original 3CV1500A7. If you're careful, you can probably drill and tap
right between a pair of the cooling fins - and even do it on a lower portion
of the anode to match the height of the horizontally-mounted RFC and
minimize the wire reach. Just how much sheet metal was used to close off
the section left by the water-vapor condenser block?
I don't look forward to the day that I'll need to make a similar conversion.
I am hoping to cut the bolier from a dud and weld it onto a new 3CX1000A7.
The tubes are otherwise identical except for the boiler. I presently have
three vapor tubes remaining, a stash of OEM plumbing parts, and hope these
will last until I get into retirement.
-Paul, W9AC
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|