Back when I worked for EIT, I had to build detonators by hand. Essentially
they were nothing more than a dc-dc amp with a boost. Anyhow, I used to use
a chemical substance that was fairly high pH. I would dip the wire in it,
wait about 10 seconds and wipe it off. It would make the enamel look like a
gel. The one thing I do remember about it that if I got it on my skin, it
would burn like the dickens. I think G-C made it. But this is going back
about 25 years.
Mike(y)
W3SLK
----- Original Message -----
From: "Joe Subich" <joe@subich.com>
To: <topband@contesting.com>; <amps@contesting.com>
Sent: Sunday, February 20, 2005 1:14 PM
Subject: [Amps] Removing enamel insulation?
Does anyone have a good way to remove enamel (Formvar?) from thin wires?
Scraping/sanding works fine for large wires but doesn't work too well
for thin wires.
Is there a chemical that will do the job (dip/wipe)?
I'm looking to wind some small toroid transformers (receive/low power)
and need to strip the wires close to the core after I have would the
transformer.
73,
... Joe, K4IK
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|